Skip to main content

MetSIP Homes


Traditional brick & cavity finish

A traditional brick and cavity finish can be used with MetSIP Panel. Brick ties are screwed to the face of the MetSIP Panel and fixed to the brick in the normal way with insulation in the cavity.


Insulation is fixed directly on to the MetSIP Panel, thin coat render and/or brick slips are then applied.

Top hat rails

Top hat rails are fixed to the MetSIP Panel to create a cavity, then phenolic foam and thin coat render and/or brick slips are applied: Dash finish, Cedar cladding and Tiling. This complies with the NHBC requirements for a drain cavity.

MetSIP Internal Walling System

MetSIP Internal Walling System has excellent sound proofing characteristics. Panels can be pre-chased to provide conduits for electrical and plumbing services. The wall is then finished with plasterboard: One layer of 12.5mm each side 48bd reduction and One layer of 15mm fireboard.

MetSIP Structural Walling

MetSIP Structural Walling can be used as an internal load bearing wall. Battens are fixed to the panel to create a void for services. The wall is finished with plasterboard.

Composite Deck, Beam and block, concrete plank or timber floor

Option of composite deck, beam and block, concrete plank or timber floor installed on top of MetSIP Panel.